SFE curves of Eichhornia crassipes are measured for different pressure (200, 250, and 300 bar), ethanol content (0 and 5 wt.%), and CO2 flow rate (5.0, 7.5 and 10.0 g min(-1)) conditions, and studied in terms of total (eta(total)) and stigmasterol (eta(stigm)) extraction yields. Ethanol addition was able to increase total yield up to 60% within the 6 h of extraction, reaching up to eta(total) = 1.25 (wt.%). For stigmasterol uptake, two yield plateaus were observed within the six runs: one at eta(stigm) = 0.17 (wt.%) for 0.0 (wt.%) ethanol and the other at 0.23 (wt.%) for 5.0 (wt.%) ethanol, which suggests that the attainable practical amount of extractives depends on whether cosolvent is used or not. Simplified modeling disclosed that both intra-particle diffusion and film diffusion may be present in the SFE process. On the other hand, the broken plus intact cells (BIC) model of Sovova allowed to fit experimental data with deviations of 4.20% for eta(total) and 4.02% for eta(stigm) and to get instructive insights on the process. In fact, BIC model evidenced the existence of a selectivity advantage favorable to stigmasterol that is driven by kinetics rather than by solubility, which is corroborated by the fact that shorter extraction periods were noticed in stigmasterol yield curves than in the global extract yield curves. In the whole, these results and insights support the realization of scale-up assays and provide a contribution for the valorization of water hyacinth through a green process devoted to the production of stigmasterol enriched extracts. (C) 2016 Elsevier B.V. All rights reserved.