화학공학소재연구정보센터
Polymer, Vol.90, 67-75, 2016
Effect of cooling rate on crystal polymorphism in beta-nucleated isotactic polypropylene as revealed by a combined WAXS/FSC analysis
The efficiency of linear trans gamma-quinacridone to nucleate formation of beta-crystals in isotactic polypropylene (iPP) at rapid cooling conditions has been evaluated by a combination of fast scanning chip calorimetry (FSC) and microfocus wide-angle X-ray scattering (WAXS). For samples containing different amount of gamma-quinacridone, FSC cooling experiments revealed information about a critical cooling rate above which the crystallization temperature decreases to below 105 degrees C, that is, to temperatures at which the growth rate of alpha-crystals is higher than that of beta-crystals. Microfocus WAXS analysis was then applied to gain information about the competition of formation of beta- and alpha-crystals in samples prepared at well-defined conditions of cooling at rates up to 1000 K/s in the FSC. For iPP containing 1 and 500 ppm gamma-quinacridone, the crystallization temperature is lower than 105 degrees C on cooling faster about 10 and 70 K/s, respectively, which then on further increase of the cooling rate leads to a distinct reduction of the beta-crystal fraction. The study may be considered as a first successful attempt to quantify and interpret beta-crystal formation in iPP containing gamma-quinacridone at processing-relevant cooling conditions in the shed of light of the different temperature-dependence of the growth rates of alpha- and beta-crystals. (C) 2016 Elsevier Ltd. All rights reserved.