Although basic investigations on wood chip material properties haven been carried out, only few studies deal with transport of wood chips, despite the fact that significant problems are commonly observed when feeding biomass in industrial applications. Within the work presented, basic bulk material properties were measured and experiments carried out with a system consisting of a hopper, agitator and a screw conveyor. The aim of this study was to investigate how three different wood chip grades and two blends of wood chips influence typical design parameters, such as mass flow and driving torque, of a biomass feeding system. The measured basic bulk properties are in good overall agreement with the literature. However, discrepancies were discovered between two standardized methods for determination of the bulk density. The results for the driving torque, mass flow and mass-related energy consumption showed that different grades of wood chips can alter these values considerably. Between two wood chip grades, a twice as high torque was recorded, while a third grade could not be fed due to jamming. One of the major findings of this study is that mixing a rather small amount of a high-fine content grade with the non-feedable grade of wood chips resulted in a blend which inhibited jamming during the screw feeding process. (C) 2016 The Authors. Published by Elsevier Ltd. This is an open access article under the CC BY-NC-ND license.