Polyvinylidene fluoride (PVDF) hollow fiber membranes were prepared by dry/wet and wet phase inversion methods. Zn spinning these PVDF hollow fibers, dimethylacetamide (DMAc) and polyvinyl pyrrolidone (PVP) were used as a solvent and an additive, respectively. Water was used as the external coagulant. Water or ethanol was used as the internal coagulants. The membranes were characterized in terms of water flux, molecular weight cut-off for the wet membranes. Gas permeation fluxes and effective surface porosity were determined by a gas permeation method for the dried membranes. The cross-sectional structures were examined by scanning electron microscopy. The effects of polymer concentration, air-gap, PVP molecular weight, PVP content in the polymer dope, and the internal coagulant on the permeation properties and membrane structures were examined. Highly permeable PVDF hollow fiber membranes could be prepared from a polymer dope containing low molecular weight PVP and using ethanol as the internal coagulant.