An efficient technique for drag reduction uses dilute solutions of a few p.p.m. of polymers. A possible reduction in drag of up to 80% is achieved. Several experimental observations have been made which tend to indicate that the polymers modify the turbulence structures within the buffer layer. Flow visualisations have shown that the changes consist of a weakening of the strength of the streamwise vortices. Existing literature reveals no attempts of numerical simulation of this phenomenon. In this paper an approach is pursued by using a constitutive equation which relates the elongation viscosity to the local properties of the flow. According to this model this viscosity is large in zones where the amount of strain rate is greater than the amount of vorticity, and is zero when the vorticity exceeds the strain rate. Simulations have been performed in a ＇＇minimal channel＇＇ to give good resolution with a limited number of grid points. The accuracy of the method is tested by comparison with the results of other techniques. For simulations with polymers, quantitative comparisons cannot be made, but the results reproduce the qualitative outputs of the experiments. The mean streamwise velocity is modified in the buffer layer; the peak of the streamwise turbulent intensity, in wall units, increases and its maximum moves far from the wail; and the vertical turbulent intensity is largely reduced in the wall region. An interesting outcome from both the simulation and the experiments is that the strength of the longitudinal vortices is reduced when the polymers are present.