Preparation of superhydrophobic materials inspired by nature has attracted a great scientific interest in recent decades. Some of these materials have hierarchical lotus -like structures, i.e. micro- and nano objects coated by hydrophobic compounds. A major challenge of applying the superhydrophobic surfaces for the self-cleaning coatings preparation is their improved efficiency in varying atmospheric conditions, e.g. UV light. The objective of this research work was to investigate the effect of the different chemical structure and the surface free energy on the hydrophobic and tribological properties of the alkylsilanes and fluoroalkylsilanes deposited on silicon wafers, glass slides and epoxy resin. Tribological and hydrophobic properties of the modified surfaces were correlated with their chemical structures. Chemical structures of the deposited materials were examined by using Fourier transform infrared (FT-IR) spectroscopy and hydrophobic properties were investigated by water contact angle (WCA) and surface free energy (SFE) measurements. The modified surfaces exhibited water contact angles of above 100 for the selected modifiers. It was noticed that the replacement of hydrogen atoms by fluorine atoms in alkyl chain caused an increase in the water contact angle values and a decrease in friction coefficients. The obtained results showed that the carbon chain length of a modifier and its chemical structure can strongly affect the hydrophobic and tribological properties of the modified surfaces. The highest values of WCA, lowest values of SFE and coefficient of friction were obtained for samples covered by fluorinated compounds. Moreover, some preliminary aging test was performed to give an insight into the effectiveness of deposited alkylsilanes and fluoroalkylsilanes coatings. After accelerated UV exposure, no significant changes in the chemical structure, hydrophobic and tribological properties of the modified surfaces were noticed. The samples degradation was not observed and hydrophobic effect was maintained in UV light what can be promising in efficient self-cleaning coatings obtaining. (C) 2016 Elsevier B.V. All rights reserved.