The full coverage of the perovskite film on the substrate surface is of significant importance for the high performance perovskite solar cells. In order to obtain full coverage perovskite films by one-step deposition method, the microstructures of both uncovered areas and covered areas of the CH3NH3PbI3 film are comparatively investigated. Results show that the uncovered area indeed has an ultra-thin layer of CH3NH3PbI3 film which is too thin to cover the rough surface morphology of the substrate, and the localized solute accumulation due to long crystal growth time is responsible for the non-full coverage of the perovskite film. Then by decreasing the crystal growth time, the localized solute accumulation is eliminated gradually and subsequently a full coverage of perovskite film on substrate surface is realized. As a result, the perovskite solar cells show a conversion efficiency of similar to 13% with the uniform and full coverage perovskite film. (C) 2016 Elsevier B.V. All rights reserved.