Systematic microstructural statistics for 3 mol% yttria-stabilized zirconia synthesized by both conventional sintering and flash sintering with AC and DC current were obtained. Within the gage section, flash sintered microstructures were indistinguishable from those synthesized by conventional sintering procedures. With both techniques, full densification was obtained. However, from both AC and DC flash sintered specimens, heterogeneous grain size distributions and residual porosity were observed in the proximity of the electrodes. After DC sintering, an almost 400 times increased average grain size was observed near cathode compared to the gage section, unlike areas close to the anode. Concepts of Joule heating alone were not sufficient to explain the experimental observations. Instead, the activation energy for grain growth close to the cathode is lowered considerably during flash sintering, hence suggesting that electrode effects can cause significant heterogeneities in microstructure evolution during flash sintering. Microstructural characterization further indicated that microfracturing during green-pressing and variations in contact resistance between the electrodes and the ceramic may also contribute to grain size gradients and hence local variations of physical properties.