Inorganic Chemistry, Vol.56, No.1, 84-91, 2017
Structural Stability, Vibrational Properties, and Photoluminescence in CsSnI3 Perovskite upon the Addition of SnF2
The CsSnI3 perovskite and the corresponding SnF2-containing material with nominal composition CsSnI2.95F0.05 were synthesized by solid-state reactions and structurally characterized by powder X-ray diffraction. Both materials undergo rapid phase transformation upon exposure to air from the black orthorhombic phase (B-gamma-CsSnI3) to the yellow orthorhombic phase (Y-CsSnI3), followed by irreversible oxidation into Cs2SnI6 within several hours. The phase transition occurs at a significantly lower rate in the SnF2-containing material rather than in the pure perovskite. The high hole-carrier concentration of the materials prohibits the detection of Raman signals for B-gamma-CsSnI3 and induces a very strong plasmonic reflectance in the far-IR. In contrast, far-IR phonon bands and a rich Raman spectrum are observed for the Y-CsSnI3 modification below 140 cm(-1) with weak frequency shift gradients versus temperatures between -95 and +170 degrees C. Above 170 degrees C, the signal is lost due to B-alpha-CsSnI3 re-formation. The photoluminescence spectra exhibit residual blue transformation initiation.