In this work, the effects of operational parameters, initial phosphorus concentration and molar ratios of Ca/P and NH4-N/P (further in the text N/P), on the nature and purity of precipitated phosphorus products have been investigated in an artificial system that mimics the supernatant in wastewater treatment plants. Metastable zone width was determined for two target phosphorus products: DCPD (dicalcium phosphate dihydrate) and HAp (hydroxyapatite) in the range of pH 4.5-7. HAp crystallizes at final pH higher than 6.3 while DCPD crystallizes at the final pH in between 4.7 and 5.7. At the final pH 5.7-6.3 and at pH lower than 4.7 the mixtures of DCPD and HAp were obtained. It was observed that N/P ratio affects not only the metastable zone width but also the kinetics of crystal growth for both DCPD and HAp: the higher the N/P ratio, the lower is the growth rate for both P-products. Investigation of the effect of Ca/P and N/P ratios on the nucleation and crystal growth of DCPD in batch crystallization experiment was performed. It showed that at high supersaturation level, crystals with larger median size can be obtained at higher N/P ratio despite the negative effects of N/P ratio on the growth rate of the crystals.