Fracturing of low-permeability source rocks is induced by pore-pressure changes caused by the conversion of organic matter to less dense fluids (oil and gas); these fractures increase the permeability and provide pathways for hydrocarbon migration. An equation for the pressure change is derived using four major assumptions. (1) The permeability of the source rock is negligibly small (0.01 mu d; 10(-20) m(2)) so that the pore-pressure buildup by the conversion is much faster than its dissipation by pore-fluid flow. (2) The stress state is isotropic so that horizontal and vertical stresses are equal. The source rock fails when the pore pressure equals the overburden pressure. (3) The properties of the rock, organic matter, and fluids remain constant during oil generation. This assumption is valid when the change in depth (i.e., pressure and temperature) is small. (4) Only two reaction rates are required for the conversions, a low-temperature reaction rate for the kerogen/oil conversion (E approximate to 24 kcal/mol, A approximate to 10(14)/m.y.) and a high-temperature reaction rate for oil/gas conversion (E approximate to 52 kcal/mol, A approximate to 5.5 x 10(26)/m.y.). The equations for generation rate and pressure change are applied to the Austin source rock by adjusting the several variables to fit geochemical data, core saturations, and observed levels of oil and gas production. This application demonstrates that the equations are easily applied in calculating depths of primary migration for low-permeability source rocks.