Benzyl phenyl ether (BPE), phenethyl phenyl ether (PPE) and diphenyl ether (DPE) have been selected as model compounds of the most abundant and significant ether linkages found within the complex structure of lignin (e.g. alpha-O-4, beta-O-4, and 4-O-5, respectively). The catalytic hydrogenolysis of these compounds has been carried out using several Ru, Pd and Ni catalysts supported over different metal oxides (e.g. Al2O3, ZrO2, TiO2) and carbon materials (e.g. active carbon, multiwall carbon nanotubes). The conversion of these compounds at relevant hydroprocessing conditions (150 degrees C, 25 bar-g in H-2 atmosphere) is much dependent on the labile nature of the relevant ether bonds of the selected model compounds. Conversion levels for the three compounds increases in the following order: DPE (4-O-5 linkage) < PPE (beta-O-4) < BPE (alpha-O-4). Product distribution is also dependent on the chemical structure of the raw material subjected to catalytic hydroprocessing, with BPE and DPE mainly yielding aromatic monomers, whilst fully saturated monomers are the main reaction products when PPE is hydroprocessed. The reaction mechanisms upon hydroprocessing vary from one model compound to another, being hydrogenolysis the prevailing route in the catalytic hydroprocessing of BPE and DPE, whereas competing reaction pathways between dimer hydrogenation and hydrogenolysis of the C-O bond occur for the PPE molecule. The conversion and selectivity to relevant hydrogenolysis products are also dependent on the catalyst used. Ru-based catalysts are the most active followed by Pd - based and Ni-based, whereas selectivity to aromatic monomers increases in the reverse order (Ni > Pd > Ru). The catalytic systems with easier reducible species performes better in the conversion of the dimer models. Besides, a preliminary study on the catalytic depolymerization of a real lignin stream (lignin-containing 2G bioethanol plants stillage) has been carried out. Detailed characterization by C-13-H-1 heteronuclear single-quantum correlation spectroscopy (HSQC) showed that on 5 wt.% Ru/C it is possible to achieve 50% desapearance of the most abundant lignin ether bond (i.e. beta-O-4) and liquid yields above 50 wt.%.