Process intensification of heterogeneous TiO2 photocatalysis using a new type of static mixer micro-m eso-structured-reactor, based on the NETmix reactor, was evaluated to promote the hexavalent chromium reduction to its trivalent state, in the presence of sacrificial agents. The photocatalytic micro-meso-structured reactor comprises a back acrylic slab where chambers and channels are imprinted and a frontal borosilicate slab with especially high UV transparency, irradiated by simulated solar light. An UV transparent cellulose acetate (CA) sheet coated with TiO2-P25 by a simple spray method was assembled between the two slabs of the photoreactor. The reactor geometry provides an efficient exposure of TiO2-P25 CA sheets to radiation, with an illuminated surface per unit of volume inside the reactor of 470 m(2) m(-3) and 1.36 g TiO2 per liter of liquid inside the reactor. Beyond that, it provides a good degree of mixing using a laminar flow, maximizing heterogeneous and homogeneous Cr(VI) reduction reactions. Firstly, different organic species were tested as hole scavengers in order to avoid the Cr(III) re-oxidation. The effect of the degree of mixing inside the photoreactor, according to the Reynolds number, on the Cr (VI) photocatalytic reduction was then evaluated. Following, operating conditions such as TiO2 mass, tartaric acid concentration, pH value, temperature and initial Cr(VI) concentration were analyzed. Results indicate high reduction rates (1 mmol Cr(VI)m(illuminated)(-3) volume s(-1)) and a photonic efficiency of 3.96% for Re = 830, 30 mg TiO2 and a Cr(VI):tartaric acid molar ratio of 1:90 at pH 3.0 and 25 degrees C. Finally, the CA sheets coated with thin films of TiO2-P25 showed to be suitable for continuous Cr(VI) reduction, without losing efficiency during 3 consecutive photocatalytic cycles. (C) 2016 Elsevier B.V. All rights reserved.