The growth kinetics of a film formed by the thermal decomposition of dimethyl disulfide on an iron foil are measured using a microbalance where the growth kinetics are parabolic (film thickness X varies with time as X-2 proportional to t) at high reaction temperatures and pressures, indicating that it is limited by diffusion through the film. The activation energy for this process is 54.5 +/- 0.5 kcal/mol. The growth rate becomes linear as the reaction temperature and/or reactant pressure is lowered, indicating that, under these circumstances, the reaction rate is limited by thermal decomposition of dimethyl disulfide at the growing interface. The activation energy for thermal decomposition at the interface is found to be 37.6 +/- 0.7 kcal/mol, and a half-order kinetics pressure dependence for the surface reaction rate is found consistent with a reaction limited by the rate of dimethyl disulfide dissociation. Analysis of the resulting film using Raman and X-ray photoelectron spectroscopies as well as X-ray diffraction reveal the formation of FeS, which may be slightly nonstoichiometric. This film is similar to that formed by methanethiol, suggesting that they may both initially form a surface thiolate species that further reacts to form FeS. The half-order reaction kinetics noted above are consistent with this. Measurement of dimethyl disulfide as an extreme-pressure (antiseizure) additive reveals a plateau at an applied load of similar to 4000 N in the seizure load versus additive concentration curve. It has previously been suggested that the plateau corresponds to the load at which the interface reaches the melting point of the solid lubricant layer (in this case proposed to be FeS). Estimation of the interfacial temperature using a method developed previously yields an interfacial temperature of similar to 1480 K, in good agreement with the melting point of FeS.