High-entropy alloy (AlCrNbSiTiV)N nitride films are prepared using direct current (dc) reactive magnetron sputtering, with an equiatomic AlCrNbSiTiV alloy target. Experiments using the grey-Taguchi method are conducted to determine the effect of deposition parameters (dc power, substrate temperature, N-2/(N-2+Ar) flow rate and substrate bias) on the microstructure, mechanical and tribological properties. Orthogonal array (L(9)3(4)), signal-to-noise ratio and analysis of variance are used to analyze the effect of the deposition parameters. The coated films are examined using scanning electron microscopy, an atomic force microscope, transmission electron microscopy (TEM), a tribometer and a nanoindenter. The TEM patterns confirm that the (AlCrNbSiTiV)N nitride films have a simple face-center-cubic structure. The experimental results show that a (AlCrNbSiTiV) N film coating significantly improves the mechanical properties. In the confirmation runs, using grey relational analysis, the improvement in friction coefficient is 32.5%, in corrosion current is 28.6%, in hardness H is 29.4%, in elastic modulus E is - 18.3%, in H/E is 57.1 and in H-3/E-2 is 225.0%. The samples with (AlCrNbSiTiV)N film coating are classified as HF1 and exhibit good adhesive strength. (C) 2018 Korean Physical Society. Published by Elsevier B.V. All rights reserved.