The architecture of bimetallic nanoparticles has strong influence on durability and activity of PtM/C electrocatalysts in the oxygen electroreduction (ORR) and the methanol electro-oxidation reactions (MOR). In the present study the Pt-0.8(Cu)/C electrocatalyst was obtained by the methods of successive multistage reduction of platinum and copper from the solutions of their precursors while platinum concentration in the matrix solution was increasing step by step. The composition, structural characteristics and electrochemical behavior of this material were compared with the Pt1.0Cu/C catalyst based on the nano particles of a solid solution, which was obtained by the combined single-step chemical reduction of precursors, as well as with a commercial Pt/C sample with the same Pt-loading (20% by weight). The catalyst based on the Pt-Cu gradient nanoparticles demonstrated the highest corrosion-morphological stability in the stress-test, as well as the highest activity in ORR and MOR in the HClO4 solutions. Both of the studied bimetallic catalysts lose a significant amount of copper during the standardizing cycling and the stress-test. In the stabilized composition of the "gradient catalyst" the residual copper content, however, is considerably higher than that of the catalyst with the solid solution nanoparticles. The positive features of the electrochemical behavior of Pt-0.8(Cu)/C catalyst arise apparently due to the faster formation of a durable protective layer of platinum on the surface of nanoparticles in the process of functioning, compared to the analogue based on the nanoparticles of the solid solution. High stability and activity of Pt0.8(Cu)/C compared to the Pt/C analogue are associated with the larger size of the nanoparticles and the promoting influence of residual copper on the catalytical activity of platinum. (C) 2017 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.