The ability to relax a macroscopically applied stress is often associated with molecular mobility, or the possibility for a molecule to move outside the confines of its current position, within the material of which the stress is applied. Here, a viscoelastic constitutive analysis is used to investigate the counterintuitive experimental observation of "mobility decrease with increased deformation through yield" [1] for a glass forming polymer during stress relaxation while under compressive and tensile loading conditions. The behavior of an epoxy thermoset is examined using an extensively validated, thermorheologically simple, material "clock" model, the Simplified Potential Energy Clock (SPEC) model.[2] This methodology allows for a comparison between the linear viscoelastic (LVE) limit and the true non-linear viscoelastic (NLVE) representation and enables exploration of a wide range of conditions that are not practical to investigate experimentally. The model predicts the behavior previously described as "mobility decrease with increased deformation" in the LVE limit and at low strain rates for NLVE. Only when loading rates are sufficient to decrease the material shift factor by multiple orders of magnitude is the anticipated deformation induced mobility or "mobility increase with increased deformation" observed. While the model has not been "trained" for these behaviors, it also predicts that the normalized stress relaxation response is indistinguishable amongst strain levels in the "post-yield" region, as has been experimentally reported. At long time, which has not been examined experimentally, the model predicts that even the normalized relaxation curves that exhibit "mobility increase with increased deformation" "cross back over" and return to the LVE ordering. These findings demonstrate the ability of rheologically simple models to represent the counter-intuitive experimentally measured material response and present predictions at long time scales that could be tested experimentally. (C) 2018 Elsevier Ltd. All rights reserved.