To advance knowledge of the beneficial effects of K in Cu(In,Ga)(Se,S)(2) (GIGS) photovoltaic (PV) absorbers, recent Cu-K-In-Se phase growth studies have been extended to PV performance. First, the effect of distributing K throughout bulk Cu1-xKxInSe2 absorbers at low K/(K + Cu) compositions (0 <= x <= 0.30) was studied. Efficiency, open-circuit voltage (V-oc), and fill factor (FF) were greatly enhanced for x similar to 0.07, resulting in an officially measured 15.0%-efficient solar cell, matching the world record CuInSe2 efficiency. The improvements were a result of reduced interface and bulk recombination, relative to CuInSe2 (x similar to 0). However, higher x compositions had reduced efficiency, short-circuit current density (J(sc)), and FF due to greatly increased interface recombination, relative to the x similar to 0 baseline. Next, the effect of confining K at the absorber/buffer interface at high K/(K + Cu) compositions (0.30 <= x <= 0.92) was researched. Previous work showed that these surface layer growth conditions produced CuInSe2 with a large phase fraction of KInSe2. After optimization (75 inn surface layer with x similar to 0.41), these KInSe2 surface samples exhibited increased efficiency (officially 14.9%), Voc, and FF as a result of decreased interface recombination. The KInSe2 surfaces had features similar to previous reports for KF post-deposition treatments (PDTs) used in world record CIGS solar cells taken as indirect evidence that KInSe2 can form during these PDTs. Both the bulk and surface growth processes greatly reduced interface recombination. However, the KInSe2 surface had higher K levels near the surface, greater lifetimes, and increased inversion near the buffer interface, relative to the champion bulk Cu1-xKxInSe2 absorber. These characteristics demonstrate that K may benefit PV performance by different mechanisms at the surface and in the absorber bulk.