The aim of this work is the demonstration of a surge prevention technique for advanced gas turbine cycles. There is significant surge risk in dynamic operation for turbines connected with large volume size additional components, such as a fuel cell stack, a saturator, a solar receiver or a heat exchanger for external combustion. In comparison with standard gas turbines, the volume size generates different behaviour during dynamic operations (with significant surge risk), especially considering that such additional components are including important dynamic constraints. In order to prevent the surge events, a vibration analysis was carried out to develop precursors which are able to highlight the approach of this unstable operative zone. Since the sub-synchronous content of the measured vibrations is significantly increasing approaching the surge line, special attention was devoted to this parameter. The demonstration of a surge prevention system based on the sub-synchronous vibration content was carried out at the Innovative Energy Systems Laboratory of the University of Genoa. In this laboratory, a recuperated microturbine connected with a large size vessel was used. Starting from the stable operation, closing a valve in the main air line or increasing the compressor inlet temperature produced operative conditions with significant surge risk. The increase in sub-synchronous vibration content detected by the control system was used to perform an active operation (bleed valve opening) to avoid the approaching surge event.