Single-molecule localization microscopy (SMLM) has created the opportunity of pushing fluorescence microscopy from being a biological imaging tool to a surface characterization and possibly even a quantitative analytical tool. The latter could be achieved by molecular counting using pointillist SMLM data sets. However, SMLM is especially sensitive to background fluorescent signals, which influences any subsequent analysis. Therefore, fabricating sensing surfaces that resist nonspecific adsorption of proteins, even after multiple modification steps, has become paramount. Herein is reported two different ways to modify surfaces: dichlorodimethylsilane-biotinylated bovine serum albumin-Tween-20 (DbT20) and poly-L-lysine grafted polyethylene glycol (PLL-PEG) mixed with biotinylated PLL-PEG (PLL-PEG/PEGbiotin). The results show that the ability to resist nonspecific adsorption of DbT20 surfaces deteriorates with an increase in the number of modification steps required after the addition of the DbT20, which limits the applicability of this surface for SMLM. As such, a new surface for SMLM that employs PLL-PEG/PEGbiotin was developed that exhibits ultralow amounts of nonspecific protein adsorption even after many modification steps. The utility of the surface was demonstrated for human influenza hemagglutinin-tagged mEos2, which was directly pulled down from cell lysates onto the PLL-PEG/PEGbiotin surface. The results strongly indicated that the PLL-PEG/PEGbiotin surface satisfies the criteria of SMLM imaging of a negligible background signal and negligible nonspecific adsorption.