Solar thermal power plants with central receiver and thermal storage are expected to be one key technology in future electricity generation, because they are renewable and due to the thermal storage independent of the current solar radiation. State-of-the-art solar power plants often use molten nitrate salts as heat transfer fluid. The use of liquid sodium instead leads to lower electricity generation costs. Sodium has a high thermal conductivity and thus large heat transfer rates are possible. Hence, a smaller absorber surface is sufficient for the same thermal power. As a result, the sodium receiver achieves a higher efficiency at lower investment cost. Additionally, the aiming strategy, which reduces the peak heat flux on molten salt receivers isn't necessary for sodium. Even at high heat flux densities, the absorber tubes will be cooled sufficiently due to the high heat transfer coefficients. Therefore, the sodium receiver in this analysis is designed for one single aim point, resulting mean in a heat flux density of (q)over dot(mean) = 1.06 MW/m(2) and (q)over dot(peak) = 2.99 MW/m(2). The state-of-the-art system with molten salt considers (q)over dot(mean) = 0.51 MW/m(2) and (q)over dot(peak) = 1.0 MW/m(2). The presented techno-economic analysis of two sodium based concepts compared to a reference system with molten salt results in up to 16% lower electricity generation costs.