Placing an encapsulated phase-change material (PCM) on top of a packed bed of sensible filler material is an effective way of reducing the drop in the heat-transfer fluid (HTF) outflow temperature during discharging associated with a sensible thermal-energy storage (TES). So far, the literature lacks guidelines for the design of a combined sensible/latent TES. This study aims at developing a new method for the design of combined TES based on non-dimensional analysis. The method will provide a designer with non-dimensional plots, produced from quasi-steady-state results of simulations with a one-dimensional model, that relate performance parameters to geometrical, thermophysical, and operational parameters of the combined TES. In this paper, a simplified version of the method is demonstrated that allows the selection of a metallic PCM and its amount such that a specified drop in the HTF outflow temperature is attained during discharging, assuming a fixed sensible section of natural rocks and air as HTF. The plots show that the drop in the outflow temperature during discharging is minimized by selecting a PCM with a melting temperature equal to 98% of the HTF inflow temperature during charging. The plots also show that the heat of fusion, provided it exceeds a threshold, has a subordinate effect on the drop in the outflow temperature. Finally, the plots show that a smaller heat of fusion can be compensated with a larger height of the latent section. The method is illustrated with a specific example.