The miscible displacement of aqueous lignin solutions (model black liquor) by water from beds formed from glass beads was studied as a function of the presence of cationic polymer in the wash water, bed structure, lignin concentration, and superficial flow rate. The displacement behaviors in homogeneous beds formed fi om fine beads (121 mu m) were compared with results of experiments using a channel bed consisting of a bed formed from fine beads surrounding a channel of coarse beads (638 mu m) running the length of the bed in the flow direction. Washing efficiencies, defined as the fraction of lignin removed when one pore volume of eluate was collected, were 84-93% for homogeneous beds washed with water compared with 31-33% for the channel bed; the range in efficiencies reflects the influence of other variables The presence of cationic polymer in the wash water enhanced the washing efficiency by 1.7 to 2 times with a corresponding 20 to 35% decrease in the permeability of the central channel in the channel bed. The improved washing with polymer was due to selective plugging of the central channel with precipitate formed from complex formation between anionic lignin in the black liquor and the cationic polymer. Breakthrough curves obtained from 12 microconductivity probes located throughout the bed showed that mixing of lignin solution (high conductivity) with wash water (low conductivity) in the displacement front, as expressed by a mixing length, was a maximum in the coarse bead channel and was decreased when the wash water contained cationic polymer.