The paper reports the electrochemical deposition of nanocrystalline nickel and composite nickel-titania films as effective electrocatalysts for the hydrogen evolution reaction. To produce the composite Ni/TiO2 electrodeposits, a plating bath based on a deep eutectic solvent, a novel kind of ionic liquids, was used for the first time. The electrolyte contained ethaline (a eutectic mixture of choline chloride and ethylene glycol), 1 M NiCl2 center dot 6H(2)O and the addition of extra water (3, 6, 9 mol dm(-3)). Titania dispersed phase was introduced into the electrolyte as nanopowder Degussa P 25 (0-10 g dm(-3)). It was shown that the introduction of extra water to the plating bath allowed appreciably increasing the content of TiO2 phase in the coating (from ca. 2 to 10 wt%). The effects of electrolysis conditions on the TiO2 content in the coatings, surface morphology and microstructure were determined. The results of voltammetry measurements showed that the Ni and composite Ni/TiO2 coatings electrodeposited from the plating electrolyte based on a deep eutectic solvent exhibit improved electrocatalytic properties towards the hydrogen evolution reaction as compared with deposits obtained from commonly used aqueous electrolytes. The mechanism of the hydrogen evolution reaction on the Ni and composite Ni/TiO2 coatings is a combination of Volmer-Heyrovsky reactions. The introduction of TiO2 particles into the nickel matrix results in the acceleration of the hydrogen evolution reaction. An improved catalytic activity of Ni/TiO2 composites towards the hydrogen evolution reaction can be associated with the presence of titanium-containing redox couples on the surface. (C) 2019 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.