Reliable sealing is necessary for the stable operation of proton exchange membrane fuel cell (PEMFC). In practical application, various materials have been tried in PEMFC sealing. However, the mechanical properties of these sealing materials, which play a key role in the sealing stability, have not been fully understood in PEMFC environment, especially after long-term operation. In this paper, according to the operating environment of PEMFC, sealing material experiments are carried out to explore the differences in mechanical behaviors of sealing materials, including silicone rubber (SR), fluororubber (FR), nitrile rubber (NBR) and ethylene-propylene-diene-terpolymer rubber (EPDM) and the variation of mechanical properties of these sealing materials is predicted as time goes on. The results indicate that compression rate has a great influence on sealing contact stress. SR and EPDM, with the variation of 0.15 MPa and 0.45 MPa in stress, show the best and worst mechanical stability at different compression rates, respectively. In terms of temperature, it is found that SR can adapt to different operating temperature of PEMFC and only 18% variation is found from 20 degrees C to 100 degrees C. Finally, based on Time-Temperature Superposition (Ti's), high temperature experiments are conducted to predict long-term relaxation stress under PEMFC working condition. The analysis results are beneficial for choosing suitable sealing material, and it can also be applied to predict sealing ability in PEMFC. (C) 2019 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.