Dense colloidal suspensions are processed in a wide variety of industries. Challenges for pumping suspensions and slurries at high concentrations include shear thickening and dilation, which can have deleterious consequences. These systems are shear sensitive close to the jamming point, meaning that a significant increase in high shear viscosity can be observed with just a few percent change in volume fractions. Therefore, accurate and rapid determination of the jamming point can greatly aid formulation. Typically, conventional rheometry identifies the jamming point by a time-consuming process, whereby multiple flow curves of suspensions of different volume fraction are measured and extrapolated to the volume fraction where the viscosity diverges. We present an alternative approach for rapid, one-step, experimental determination of the jamming point for aqueous suspensions. The procedure monitors the shear stress under constant shear stress or shear rate as the sample is dewatered using immobilization cell rheometry, until the viscosity diverges. The method is validated by comparing the results of this work with conventional rheometry for a model suspension. Then it is applied to examine the effect of grafting a short-chain polymer to particles, comprising an industrial suspension of silica-coated titania. Polymeric coating of the particles increases the jamming concentration and mitigates shear thickening, qualitatively consistent with predictions from simulations. Graphical A new method is designed to extract the jamming point of a suspension. The procedure monitors the effective viscosity under prescribed shear conditions as the suspension is dewatered using immobilization cell rheometry. The geometry moves down to accommodate solvent evaporation, until the viscosity diverges, and the jamming point is reached.