The thermal decomposition of actinide oxalates is greatly dependent on the oxidation state of the cation, the gas involved, and the physical characteristics of the precursor. In the actinides series, uranium(IV) oxalate U(C2O4)(2)center dot 6H(2)O can be viewed as a peculiar case, as its sensibility toward oxidation leads to a specific series of reactions when heating under an oxygen atmosphere. In order to clarify the disagreements existing in the literature, particularly concerning potential carbonate intermediates and the possible transitory existence of UO3, we show here an extended characterization of the different intermediates through a combination of X-ray diffraction, vibrational spectroscopies and X-ray absorption near-edge spectroscopy. In this frame, uranium oxidation was found to occur at low temperature (200 degrees C) concomitantly to the onset of oxalate groups decomposition, leading to an amorphous oxo-oxalato compound. Pursuing the thermal conversion up to 350 degrees C led to complete oxidation of U(IV) into U(VI), then to the formation of amorphous UO3 still bearing adsorbed carbonates. The first pure oxide formed during the thermal conversion was further identified to substoichiometric UO3-delta after heating at 550 degrees C. Finally, U3O8 was obtained as the final stable phase after heating above 660 degrees C. The mechanism of thermal conversion of uranium(IV) oxalate into oxide under oxygen is then driven by a complex interplay between redox reactions and decomposition of the organic fractions. Such chemical reactions were also found to significantly modify the morphology of the powder through high-temperature environmental scanning electron microscopy observations: decomposition led to a 20% reduction in the size of the aggregates, while uranium oxidation clearly promoted growth within the agglomerates.