This paper presents a scale-up procedure of parameter estimation in the selection function and breakage function from single particle impact breakage to inform the predictions at the process scale of an impact pin mill. The selection and breakage functions used in population balance model (PBM) for particle breakage in the literature are briefly reviewed. Single particle breakage tests are conducted in a vertical impact tester subject to varying impact velocities. The single particle breakage results further serve to provide the database for the parameter estimation in Vogel and Peukert model (Vogel and Peukert, 2005). The estimated parameters in the particle level are upscaled in an impact pin mill using the population balance model, which is implemented in the software gPROMS (Process Systems Enterprise, UK) (gPROMS (R) 4.1 Release Notes, 2016). The impact milling tests were carried out in an impact pin mill UPZ100 subject to four feed rates, providing the dataset for model validation. The sensitivity analysis of the PBM parameters was conducted to help identify their leverage on the particle size distribution. The scale-up procedure by specifying the parameters from single particle level to the process level of PBM demonstrates an approach to help predict the size reduction process subject to the prevailing mechanism in an impact pin mill and other milling processes alike. (C) 2020 The Society of Powder Technology Japan. Published by Elsevier B.V. and The Society of Powder Technology Japan. All rights reserved.