Perovskite solar cells (PSCs) are in the forefront of third-generation of photovoltaics and gained a lot of attention as a very promising green technology toward direct solar energy conversion to electricity. PSCs are fabricated following solution-processed techniques at low temperature and they present high power conversion efficiency exceeding 25%, enabling them to be attractive alternative to the silicon-based devices. This research work proposes an efficient and cost-effective photovoltaic (PV) pumping system based on PSCs. For this purpose, lab-scale PSCs were fabricated and their characteristics were determined. In parallel, the geometry of a synchronous reluctance motor (SynRM) driving a 350 m(3)/day water pump was optimized for maximizing the output power, while minimizing the torque ripple simultaneously. In addition, a perovskite solar array feeding the SynRM via an inverter was designed and implemented. The inverter was properly regulated by a control system which optimized the maximum available power of the PSCs solar array and the SynRM characteristics. Finally, laboratory measurements were performed, including a power generator simulating the behavior of the PSCs array feeding the SynRM. The obtained results confirmed the experimental validation of the proposed approach.