We consider coupled PDE systems comprising of a hyperbolic and a parabolic-like equation with an interface on a portion of the boundary. These models are motivated by structural acoustic problems. A. specific prototype consists of a wave equation defined on a three-dimensional bounded domain Omega coupled with a thermoelastic plate equation defined on Gamma(0)-a flat surface of the boundary partial derivative Omega. Thus, the coupling between the wave and the plate takes place on the interface To. The main issue studied here is that of uniform stability of the overall interactive model. Since the original (uncontrolled) model is only strongly stable, but not uniformly stable, the question becomes: what is the "minimal amount" of dissipation necessary to obtain uniform decay rates for the energy of the overall system? Our main result states that boundary nonlinear dissipation placed only on a suitable portion of the part of the boundary which is complementary to To, suffices for the stabilization of the entire structure. This result is new with respect to the literature on several accounts: (i) thermoelasticity is accounted for in the plate model; (ii) the plate model does not account for any type of mechanical damping, including the structural damping most often considered in the literature; (iii) there is no mechanical damping placed on the interface To; (iv) the boundary damping is nonlinear without a prescribed growth rate at the origin; (v) the undamped portions of the boundary a partial derivative Omega are subject to Neumann (rather than Dirichlet) boundary conditions, which is a recognized difficulty in the context of stabilization of wave equations, due to the fact that the strong Lopatinski condition does not hold. The main mathematical challenge is to show how the thermal energy is propagated onto the hyperbolic component of the structure. This is achieved by using a recently developed sharp theory of boundary traces corresponding to wave and plate equations, along with the analytic estimates recently established for the co-continuous semigroup associated with thermal plates subject to free boundary conditions. These trace inequalities along with the analyticity of the thermoelastic plate component allow one to establish appropriate inverse/recovery type estimates which are critical for uniform stabilization. Our main result provides "optimal" uniform decay rates for the energy function corresponding to the full structure. These rates are described by a suitable nonlinear ordinary differential equation, whose coefficients depend on the growth of the nonlinear dissipation at the origin.