Blends of linear low density polyethylene (LLDPE) and polypropylene (PP) show diverse mechanical property behavior in the published literature. The main objectives of this work were : to investigate the effect of viscosity of the component phases on the mechanical properties of such blends and to use the results to obtain a method for compatibilizing diaper manufacturing waste. The significant result of the study was that although LLDPE/PP blends are often termed "incompatible," when viscosity of the components was more closely matched to each other, increases of as much as 50% in tensile strength and modulus were observed over the "rule of mixtures" line. Also, scanning electron microscopy then showed a more diffuse interface between the component phases. Three dimensional views of plots of viscosity ratio of the blend components as a function of temperature and shear rate were used to demonstrate the closer matching of viscosities for the blend components of the higher performing blends. In processing diaper manufacturing waste, addition of a high molecular weight PP in a manufacturing scale single screw extruder, to provide a closer match of viscosities of the blend components, significantly improved mechanical properties.