Stereolithography tooling is a form of rapid tooling that has been used to injection mold limited runs of prototype parts. However, the process is not well understood and tooling life for fine mold features is difficult to predict. Injection molding processing conditions and feature geometry affect the number of parts that can be made before a mold fails. To study the effects of feature geometry, general purpose polystyrene parts were injection molded in molds made of DSM Somos 7110 stereolithography resin. The AGES build style was used, and no polishing was performed on the mold. The experimental results were compared with theoretical models developed for the two failure mechanisms for raised features in a stereolithography mold-failures during injection due to the flow pressure of the injected polymer; and failures during ejection, whereby the part pulled out a feature of the mold. Injection failures occurred in taller mold features due to the force of flow and the feature＇s geometry. Ejection failures occurred in the shorter features when the stress from the ejection force (distributed over the bond area) exceeded the yield strength of the mold material. Models were developed to predict the number of parts that a mold could make before mold features break off and were validated through experimental results.