The aim of this work was to study a new process for the continuous production of mixed-strain lactic acid bacteria starters using immobilized cells. Three strains of Lactococcus (two Lactococcus lactis subsp. lactis : KB and KBP, and one Lactococcus lactis subsp, lactis biovar diacetylactis : MD) were immobilized separately in kappa-carrageenan-locust bean gum gel beads. Continuous fermentations were carried out in a 1 L pH-controlled stirred tank reactor with a 30% (v/v) bead inoculum (strain ratio 1:1:1), continuously fed with a whey UF permeate medium, supplemented with 1.5% yeast extract and 0.1 M KCI. The effects of three parameters-pH, temperature (T), dilution rate (D), and their interactions on the composition and activity of the culture in the effluent at pseudosteady state were studied according to a rotatable central composite design, during a 53-day fermentation. The process showed a high biological stability and no strain became dominant, or was eliminated from the bioreactor. The statistical analysis showed that the three strains were differently affected by the studied parameters, and that a large range of effluent starter composition can be achieved by varying D, pH, and T. However, the acidifying characteristics were not affected by the culture conditions. A cross-contamination from other strains of the mixed culture was observed in gel beads entrapping a pure culture at the fermentation onset, and led to a biomass redistribution within the beads. However, the strain ratio (KB:KBP:MD) observed after the 53-day experiment (1:2:2) was close to the initial bead ratio (1:1:1). The beads demonstrated a high mechanical stability throughout the 53-day continuous fermentation.