Cryopreservation is widely used to preserve blood vessels for a while but is controversially suspected to affect the mechanical behavior of these allografts. The aim of this study was to determine whether differences in the three-dimensional mechanical behavior exist or not between fresh and cryopreserved arteries. Using a previously developed experimental system, in vitro inflation tests were performed on twenty segments of human fresh and cryopreserved arteries, in static conditions. Opening angles were also measured from images of rings in zero-stress state. The initial reference state was chosen as the unloaded state and tests were performed on specimens stretched at natural "in vivo" length. Mechanical measures calculated are "natural" (Hencky) strains (finite deformations), "true" (Cauchy) stresses in radial, circumferential, and longitudinal directions as well as strain energy per unit volume. Tangent moduli are derived from radial and circumferential stress-strain characteristics using non-linear curve fitting. Values of incremental and pressure-strain elastic parameters, wall stiffness, and compliance per unit length are also calculated. Results are presented in terms of characteristics of stresses and strains in the three directions, axial force, tangent moduli vs strains or stresses, and energy per unit volume, for both types of artery, with reference to transmural pressure. Detailed numerical results are given at mean transmural pressure or in the physiological range. Significant differences are indicated by statistic Student T-tests. Results obtained show that significant differences exist between rheological properties of fresh and cryopreserved segments of human artery. Strains, stresses, axial force, strain energy, and wall stiffness values highlight those differences whereas elastic parameters, compliance, and opening angle do not. The usefulness of some parameters to compare the mechanical behavior existing between fresh and cryopreserved arteries is therefore underlined.