A direct synthetic route leading to titania particles dispersed on nonporous spherical silica particles has been investigated; 5, 10, and 20% (w/w) titania/silica sols mixtures were achieved via hydrolyzation of titanium tetra-isopropxide solution in the mother liquor of a freshly prepared Sol of spherical silica particles (Stober particles). Titania/silica materials were produced by subsequent drying and calcination of the xerogels so obtained for 3 h at 400 and 600degreesC. The materials were investigated by means of thermal analyses (TGA and DSC), FT-IR, N-2 gas adsorption-desorption, powder X-ray diffraction (XRD), and transmission electron microscopy (TEM). In spite of the low surface area (13.1 m(2)/g) of the pure spherical silica particles calcined at 400degreesC, high surface area and mesoporous texture titania/silica materials were obtained (e.g., S-BET ca. 293 m(2)/g for the 10% titania/silica calcined at 400degreesC). Moreover, the materials were shown to be amorphous toward XRD up to 600degreesC, while reasonable surface areas were preserved. It has been concluded that dispersion of titania particles onto the surface of the nonporous spherical silica particles increase their roughness, therefore leading to composite materials of less firm packing and mesoporosity.