Acrylic-based copolymers of methyl methacrylate (MMA) and methacrylic acid (MAA) have been prepared by solution and bulk polymerization techniques using benzoyl peroxide (BPO) as an initiator. Three polymers were prepared with a varying ratio of MMA/MAA. In an effort to increase the hydrophilicity of the matrix, one MMA/MAA polymer was prepared by adding an additional amount of 2-hydroxy ethyl methacrylate (HEMA). All the polymers were crosslinked in situ by ethylene glycol dimethacrylate (EGDMA). These polymers were characterized by Fourier transform infrared spectroscopy and differential scanning calorimetry. Viscous flow characteristics were determined from solution viscosity and rheological measurements. Dynamic and equilibrium swelling experiments were carried out under varying pH conditions (i.e., 0.1N NaOH, UN HCl and double-distilled water). Partially crosslinked hydrogels show varying hydrophilicity because of the presence of carboxylic acid groups making them pH-responsive. Swelling increased with an increasing number of -COOH groups on the polymer backbone and the hydrophilicity varied with changing pH. Cypermethrin, a widely used pesticide, and cupric sulfate, a model micronutrient, were loaded into these pH-sensitive hydrogels to investigate their controlled release characteristics. The in vitro release rates of both compounds have been carried out under static dissolution conditions at 30degreesC. Release data have been fitted to an empirical relation to estimate transport parameters. The release results have been discussed in terms of the varying hydrophilicity of the hydrogel network polymers.