An enzyme-containing microfluidic biochip has been developed for the oxidative polymerization of phenols. The biochip consists of a simple T-junction with two feed reservoirs 20 mm apart and a microreaction channel 30 mm long. The channel is 15 pm deep and 200 pm wide at the center, giving a reaction volume of 90 nL. The biochip was fabricated using conventional photolithographic methods on a glass substrate etched using a HF-based solution. Fluid transport was enabled using electroosmotic flow. Soybean peroxidase was used as the phenol oxidizing catalyst, and in the presence of p-cresol and H2O2, essentially complete conversion of the H2O2 (the limiting substrate) occurred in the microchannel at a flow rate of ca. 290 nL/min. Thus, peroxidase was found to be intrinsically active even upon dramatic scale-down as achieved in microfluidic reactors. These results were extended to a series of phenols, thereby demonstrating that the microfluidic peroxiclase reactor may have application in high-throughput screening of phenolic polymerization reactions for use in phenolic resin synthesis. Finally, rapid growth of poly(p-cresol) on the walls of the microreaction channel could be performed in the presence of higher H2O2 concentrations. This finding suggests that solution-phase peroxiclase catalysis can be used in the controlled deposition of polymers on the walls of microreactors. (C) 2003 Wiley Periodicals.