Temperature modulated differential scanning calorimetry (TMDSC) was employed to study the melting and crystallization behavior of various polyethylenes (PEs). Samples of high density PE (HDPE), low density PE (LDPE), linear low density PE (LLDPE), and very low density PE (VLDPE) with different crystal structures and morphologies were prepared by various thermal treatments (isothermal crystallization and slow, fast, and dynamic cooling). The reversing and nonreversing contributions, measured on the experimental time scale, were varied, depending on the crystal stability. A relatively large reversing melt contribution occurs for unstable crystals formed by fast cooling compared to those from slow cooling treatments. All samples of highly branched LDPE, LLDPE, and VLDPE showed a broad exotherm before the main melting peak in the nonreversing curve, suggesting crystallization and annealing of crystals to more stable forms. Other samples of HDPE, except when cooled quickly, did not show any significant crystallization and annealing before melting. The crystallinity indicated that dynamically cooled polymers were much more crystalline, which can be attributed to crystal perfection at the lamellar surface. A reversible melting component was also detected during the quasiisothermal TMDSC measurements. Melting is often accompanied by large irreversible effects, such as crystallization and annealing, where the crystals are not at equilibrium. Such phenomena during a TMDSC scan provide information on the polymer thermal history. (C) 2003 Wiley Periodicals, Inc.