Poly(urethane-isocyanurate)s were synthesized by reacting toluene diisocyanate and poly(propylene glycol) with various stochiometric ratios (1-3) in the presence of different concentrations of dibutyltin dilaurate (DBTDL) and ferric acetylacetonate (FeAA). The influence of the NCO/OH ratio and the catalyst type and concentration on the extent of urethane and isocyanurate formation were examined using Fourier transform IR spectroscopy. No trimer formation was observed in the presence of the FeAA catalyst. The percentage of the trimer group and the trimer/urethane content were found to be increased with increasing the stochiometric ratio or DBTDL concentration. The thermal decomposition of the copolyurethanes in an inert atmosphere was studied by means of thermogravimetry (TG). The TG curves showed three decomposition steps with the principal degradation temperature at about 355-385degreesC. The effects of the NCO/OH ratio, catalyst type and concentration, and heating rate on the thermal stability of the copolyurethanes were determined. The Flynn-Wall, Kissinger, and Ozawa methods were used to calculate the activation energies of thermal decomposition. The swelling behavior of solid copolyurethanes in toluene showed that, as the DBTDL concentration and/or NCO/OH ratio increased, the swelling ratio and average molecular weight between crosslinks were decreased whereas the crosslink density was increased. The sol fraction of solid copolyurethanes was examined and found to be reduced when the percentage of DBTDL or the stochiometric ratio was raised. (C) Wiley Periodicals, Inc.