The performance of an air dehumidifier using triethylene glycol (TEG) as desiccant under hot and humid conditions was investigated. The performance of the dehumidifier was evaluated and expressed in terms of the moisture removal rate and the dehumidifier effectiveness. A packed bed column (dehumidifier) was employed, with low packing density (77 m(1)/m(3)), to provide direct contact between the air and the TEG. Two different structured packings were used, wood and aluminum. The experiments covered a wide range of parameter space that included the air and TEG flow rates, air and TEG inlet temperatures, inlet air humidity and inlet TEG concentration. The liquid flow rate investigated is much less than that covered in previous studies (< 1 kg/m(2) s). The trend of the dehumidifier performance was similar to that reported in the literature using high density and random packing. The results were compared to the Chung and Luo correlation, which over predicted the effectiveness. The Martin and Goswami correlation failed to predict the effectiveness under the conditions of this study. In the present study, it was found that the moisture removal rate increased with increasing inlet TEG concentration, TEG flow rate and air flow rate. This was seen for both the wood and the aluminum packings. In addition, the moisture removal rate is increased with increasing the inlet air temperature for the aluminum packing only. The effectiveness of the column was increased by increasing the TEG flow rate and inlet TEG temperature for the two packings. (C) 2003 Elsevier Ltd. All rights reserved.