Journal of the American Chemical Society, Vol.126, No.3, 844-850, 2004
Microwave spectroscopy measurements of rotational spectra and DFT calculations for two distinct structural isomers of 1,1'-dimethylferrocene
Microwave spectra were obtained for two distinct structural isomers of 1,1'-dimethylferrocene, an eclipsed synperiplanar isomer (phi = 0degrees, the E0 isomer), with A = 1176.9003(2) MHz, B = 898.3343(2) MHz, C = 668.7469(2) MHz, and an eclipsed synclinal isomer (phi = 72degrees, the E72 isomer) with A = 1208.7117(14) MHz, B = 806.4101(12) MHz, and C = 718.7179(8) MHz. The b-clipole, asymmetric-top spectra of both structural isomers were measured in the frequency range of 5-12 GHz using a Flygare-Balle type of spectrometer. A very good fit to observed transitions, with small distortion constants, was obtained for the E0 conformer, indicating that this conformer is nearly rigid. The deviations obtained in a similar least-squares fit for the E72 conformer are significantly larger, indicating possible fluxional behavior for this conformer. In addition, 7 out of the 26 transitions observed for the E72 isomer conformer clearly exhibit very small splittings, giving further evidence for internal motion. DFT calculations for the different possible conformations of 1,1'- dimethylferrocene arising from rotation of one methyl cyclopentadienyl ligand relative to the other about the nominal C-5 axis by an angle phi (dihedral angle) were performed using the B3PW91 functional. The calculations converged and were optimized for five structures on this torsional potential energy surface corresponding to different dihedral angles phi; three yielded energy minima, and two gave energy maxima, corresponding to transition states. The experimental results are in very good agreement with the results of the DFT calculations.