Plastic fiber composites, consisting of polypropylene (PP) or polyethylene (PE), and pinewood, big blue stem (BBS), soybean hulls, or distillers dried grain and solubles (DDGS), were prepared by extrusion. Young's modulus, tensile and flexural strengths, melt flow, shrinkage, and impact energy, with respect to the type, amount, and size of fiber on composites, were evaluated. Young's moduli under tensile load of wood, BBS, and soybean-hull fiber composites, compared with those of pure plastic controls, were either comparable or higher. Tensile strength significantly decreased for all the PP/fiber composites when compared with that of the control. Strength of BBS fiber composites was higher than or comparable to that of wood. When natural fibers were added there was a significant decrease in the melt flow index for both plastic/fiber composites. There was no significant difference in the shrinkage of all fiber/plastic composites compared to that of controls. BBS/PE plastic composites resulted in higher notched impact strength than that of wood or soybean-hull fiber composites. There was significant reduction in the unnotched impact strength compared to that of controls. BBS has the potential to be used as reinforcing materials for low-cost composites. (C) 2004 Wiley Periodicals, Inc.