In the summer of 2002, measurements were simultaneously performed to investigate the characteristics of heat flow in urban areas at three locations in Kyoto city: (1) a commercial urban area mixed with low-rise traditional residential buildings that represents the urban area of Kyoto: (2) a university campus area with lots of green zones; and (3) a plaza covered with a concrete slab which was used as a reference point of measurement. Heat flux of boundary layer over the three locations and the surface temperatures of building walls and streets were measured to investigate the urban thermal environment. For the analysis, a new simulation code was developed by combining unsteady state heat conduction of building walls and grounds, radiation heat exchange between them, and airflow by computational fluid dynamics (CFD). By using this code, the thermal environment of the urban areas such as air temperature, humidity, wind velocity, and boundary layer heat flux was predicted and compared with the measured results. It was found that this model could predict the real thermal environment of the urban area. Using this code, the effect of additional green on roofs and grounds can be investigated in order to mitigate urban heat island and to improve urban thermal environment at the street level. (C) 2004 Elsevier B.V. All rights reserved.