Different electrochemical methods such as open-circuit potential measurements, polarization techniques and electrochemical impedance spectroscopy (EIS) were used to investigate the electrochemical behavior of brass alloys with various Zn contents (5.5-38.0 mass%) and Cu-38.0Zn-Pb alloy with different Pb contents (1.0-3.4 mass%) in neutral sodium sulfate solutions. The influence of working conditions, e.g., immersion time, sulfate ions concentration and temperature on the electrochemical behavior of the different alloys was also studied. It was found that the initial corrosion rate is relatively high for alloys with the higher zinc content due to dezincification. The dezincification process initiates by selective dissolution of zinc and continues by a simultaneous dissolution of copper and zinc followed by re-deposition of copper. An increase in the lead content and immersion time in the sodium sulfate solution increases the corrosion resistance of the alloy and improves its stability. The stability of the leaded brass was considered to be due to the formation of an insoluble film of lead sulfate on its surface. The impedance data were fitted to theoretical data obtained according to an equivalent circuit model describing the electrode/electrolyte interface. The mechanism of the alloy dissolution was discussed in view of the obtained results. (C) 2004 Elsevier Ltd. All rights reserved.