Nano-sized Al2O3 particles grafted with polystyrene or polyarcrylamide were employed as fillers for fabricating epoxy based composites. Curing habit, mechanical properties and tribological performance revealed by sliding wear tests of the composites were investigated. The experimental results indicated that the nanoparticles accelerate curing of epoxy, increase composites' impact strength and decrease wear rate and frictional coefficient of the composites. The surface modification by means of grafting polymerization can further enhance the properties improvement of epoxy due to the increased filler/matrix interfacial interaction. Compared to frictional coefficient, wear rate of epoxy can be decreased more remarkably by the addition of nano-alumina when rubbing against steel. The wear mode changes from severe peeling off of unfilled epoxy to mild micro-ploughing in the case of nano-alumina filled composites. (C) 2004 Kluwer Academic Publishers.