Thin films of birnessite-type layered manganese oxides with various interlayer spacings have been prepared on a platinum electrode by a one-step electrochemical procedure. The process involves a potentiostatic oxidation of aqueous Mn2+ ions at around +1.0 V (Ag/AgCl) in the presence of tetraalkylammonium cations with different alkyl chain lengths. X-ray diffraction indicates that the films deposited with tetrabutylammonium (TBA), tetrapropylammonium (TPA), and tetraethylammonium (TEA) ions are composed of a single phase where unhydrated tetraalkylammonium ions are accommodated as a monolayer between manganese oxide layers. The interlayer spacing of the products increases in an order of TEA < TPA < TBA. The film deposited with tetramethylammonium (TMA) is a mixture of two phases relating to hydrated and unhydrated guest cations, the former being predominant probably as a result of less hydrophobic property of TMA compared to that of other tetraalkylammonium ions. The TBA(+)-intercalated Mn oxide film-coated electrode exhibits a good charge/discharge property in a KCl solution between 0 and +0.8 V. In this case, TBA(+) ions between the Mn oxide layers are rapidly replaced with K+ in solution by ion exchange, accompanying a shrinkage of the interlayer. The incorporated K+ ions as well as protons play an important role in the electrochemical conversion between Mn4+ and Mn3+ in the oxide layer. In the TBACl solution, the interlayer TBA(+) ions can be excluded electrochemically during the positive-going scan, concomitant with the oxidation of Mn3+ Sites. This causes an anodic current and the accompanying shrinkage of the interlayer. On the reverse scan, however, the compressed interlayer does not allow the incorporation of bulky TBA(+) ions from the electrolyte, with virtually no cathodic current observed. Such an obvious difference in electrochemical behavior between the two electrolytes can be recognized by considering that most of the Mn oxide surface is present inside the layered structure, not on the external surface. This indicates that the layered structure is formed over the entire film.