Dynamic mechanical analysis was performed to characterize the viscoelastic properties of binary and ternary blends of fluorocarbon elastomer (FKM), acrylic elastomer (ACM) and liquid crystalline polymer (LCP). The results showed that the storage and loss modulus of all the blends increased significantly with the weight percentage of the LCP. The glass transition temperature evaluated at the loss modulus peak, were in the range of - 10- + 5 degrees C for all the blends. The time temperature superposition principle was applied for the FKM/ACM and 20% LCP filled FKM/ACM blend in order to evaluate the changes in the viscoelastic properties of FKM/ACM blend by the addition of LCP. The Arrhenius and William-Landel-Ferry (WLF) equations were used to quantify the viscoelastic behaviour at the glass transition region. Both the blends exhibited a single relaxation, which is glass transition, observed as a peek in the loss modulus at 1 Hz. The glassy moduli of these two systems were found to be comparable, but the rubbery moduli of the LCP filled FKM/ACM was much higher than the LCP unfilled system. However, the viscoelastic behaviour of these two systems and their sensitivity to time temperature may be considered to be quite similar. (c) 2005 Elsevier Ltd. All rights reserved.