The dependence of power consumption on impeller spacing, and also in relation to gas flow rate and viscosity, in unaerated and aerated gas-liquid contactors agitated by dual Rushton- and by dual pitched blade turbines was comparatively studied. In tap water the two Rushton impellers acted independently for spacings greater than Delta H = 1.65d, while in glycerol solutions the impellers acted independently on reaching an impeller spacing equal to 1.20d; the corresponding values for the two pitched blade impellers were 1.50d for tap water, 1.07d for relatively high viscosities, and 0.53d for very high viscosity values. The Newton number Ne decreases with increasing viscosity for the dual Rushton turbine systems, while an increase of Ne can be observed with increasing viscosity for the corresponding pitched blade systems. For the dual Rushton turbines, gas flow number Q has no effect on Ne, at very high values of viscosity, while at low and relatively high viscosity values a small effect of Q on Ne can be detected. As observed for the dual Rushton turbine systems, Ne is also not affected by Q for the corresponding pitched blade systems at very high viscosity values. Flow number Q does not significantly affect the Newton number for the water-glycerol solutions with a relatively high viscosity agitated by dual pitched blade turbines, while for the aerated water systems a decrease of Ne can be observed at relatively small gas flow numbers; high values of Q do not affect the Newton number.