Activated carbons with well-developed pore structures were prepared from pistachio-nut shells by chemical activation using zinc chloride under both nitrogen atmosphere and vacuum conditions. The effects of preparation parameters on the carbon pore structure were studied in order to optimize these parameters. It was found that under vacuum conditions, the characteristics of the activated carbons produced are better than those under nitrogen atmosphere. The impregnation ratio, the activation temperature, and the activation hold time are the important parameters that influence the characteristics of the activated carbons. The optimum experimental conditions for preparing predominantly microporous activated carbons with high pore surface area and micropore Volume are an impregnation ratio of 0.75, an activation temperature of 400 degrees C, and a hold time of 1 h. Under these conditions, the BET surface areas of the carbons activated under nitrogen atmosphere and vacuum conditions were 1635.37 and 1647.16 m(2)/g, respectively. However, at a ZnCl2 impregnation ratio of 1.5, a furnace temperature of 500 degrees C, and a hold time of 2 h, the predominantly mesoporous activated carbon prepared under vacuum condition had a BET surface area of 2527 m(2)/g. Fourier transform infrared spectra were used to detect changes in the surface functional groups of the samples during the different preparation stages. (c) 2005 Elsevier Inc. All rights reserved.