Fully sulfonated poly(styrenesulfonate) brushes were grown from the surface of colloidal silica particles and used to prepare stable trichloroethylene-in-water and heptane-in-water Pickering emulsions. These particles were highly charged and colloidally stable in water but could not be dispersed in trichloroethylene or heptane. Both two-phase (emulsion plus neat water) and three-phase (emulsion separating neat oil and water phases) systems were observed, with water-continuous emulsion phases in all cases. Emulsion phases containing as much as 83% (v/v) oil were stable for over six months. Poly(styrenesulfonate)-grafted particles were very efficient emulsifiers; stable emulsion phases were prepared when using as little as 0.04 wt% particles. The emulsifying effectiveness of the poly(styrenesulfonate)-grafted silica particles can be attributed to the hydrophobicity of the vinylic polymer backbone that makes this highly charged polyelectrolyte unusually surface active at the oil/water interface.